Wireless roaming/Wallys wireless H&S design industrial wifi5/wifi6 wireless

MT7915/IPQ6000/IPQ6018/IPQ6010/IPQ4019/IPQ4029/IPQ5018/IPQ8072/IPQ8072A/IPQ8074/IPQ8074A/QCN6024/QCN9074/QCN9072/QCN9024/IPQ4018/IPQ4028/AR9223/QCA9880/QCA9882/AR9582/AR9531/AR9344 /AR9342/AX200NGW/QCA9531

Wallys is a company engaged in research and development, production, design and manufacturing of wireless. Currently, there are some researches on wireless roaming and many successful project application cases.

If there is any need, please feel free to contact us.

Skype/EMAIL/Teams：sales@wallystech.com

WEB:https://www.wallystech.com/

Introduction to Roaming:

WLAN Wireless roaming allows STAs to move between AP coverage areas without interrupting services. As shown in the figure below, STA1 keeps the service uninterrupted when it moves from the coverage of AP1 to the coverage of AP2..

WLAN Wireless roaming policies address the following issues:

1: Avoid packet loss or service interruption caused by prolonged authentication during roaming

The number and time of packet interaction during authentication, such as 802.1x authentication and Portal authentication, are larger than those during WLAN connection. Therefore, roaming requires avoiding re-authentication and authorization and key negotiation.

2: Ensure that user authorization information remains unchanged

The authentication and authorization information of users is the passport for users to access the network. If services are not interrupted after roaming, the authentication and authorization information of users on the AC must remain unchanged

3: Ensure that the user IP address remains unchanged

• 本文地址：Wireless roaming/Wallys wireless H&S design industrial wifi5/wifi6 wireless
• 本文版权归作者和AIQ共有，欢迎转载，但未经作者同意必须保留此段声明，且在文章页面明显位置给出

Application layer protocols take IP addresses and TCP/UDP sessions as the bearer of user services. After roaming, users must retain their original IP addresses so that the corresponding TCP/UDP sessions are not interrupted and data at the application layer can be forwarded normally

Classification of roaming:

Depending on whether STAs roam within the same subnet, roaming can be divided into layer 2 roaming and layer 3 roaming

Three layers of roaming:

If the VLAN ids of the two subnets are different, the two subnets reside on different network segments. Therefore, STA roaming on the two subnets is Layer 3 roaming

Second floor roaming:

The following situation occurs: The VLAN ID of two subnets is the same, but the two subnets belong to different subnets. In this case, you need to use the roaming domain to determine whether devices reside on the same subnet. Layer 2 roaming occurs only when the vlans and roaming domains are the same. Otherwise, Layer 3 roaming occurs

Basic principles of roaming

Roaming switchover process within AC

1. Switch detection: When STA detects that fast switch is about to occur, it will send a switch request to each channel.

STA monitors the beacon of each channel, finds that the new AP meets the roaming conditions, and sends probe requests to the new AP. After receiving a request in its channel, the new AP responds by sending a reply in the channel. Upon receiving the response, STA evaluates it to determine which AP is most appropriate to associate with.

1. Switch trigger: When STA reaches the roaming threshold, switch will be triggered

Different STAs have different approaches to trigger conditions:

** According to the comparison between the current AP signal strength and the neighboring AP signal strength, the switch starts when the threshold is reached

** When the service, such as packet loss rate, reaches the threshold, the switchover is started. This switchover is triggered slowly and has poor effect